History: House1465

+ !!__House Paint__

+ Walls = 413-3 Ostrich Feather (supplied by Ryland)
Power Room = Behr 720D-4 Ashwood (Satin)
Girls Bathroom = Behr 370A-2 Pale Daffodil (Satin)

+
+ Hardware:
+ Replacement Pulls in the bedroom - Birdcage Bail Design, SKU=96 926-408
+
+ !!__Sprinkler System__
+ # Turn off water in the basement
+ # Turn yellow valve off (just above the spicket)
+ # Use attachment and attach to the right side of the device outside (remove the current one and replace it with the one that should be hanging from the air compressor)
+ # Run air hose to the attachment, do not attach yet.
+ # Start the compressor. Set it to 45psi (looking to keep it between 40-50, not over 50psi
+ # Set the sprinkler to manual, set the first station to 10 minutes (time to finish setting the other stations and get the hose hooked up), set the other stations to 5 minutes.
+ # Make sure the first station is running, if so, hook up the hose to the attachment
+ # Air should be pushing out water at station one.
+ # Wait and watch the other stations, make sure to keep the PSI below 50
+ # Remove the air hose.
+ # Reattach the piece on the right
+ # Set all valves to half way open.
+ # Drain the lines to the spickets: The one to the sprinkler needs to drain back into the house. The one to the back, if you give it a quick burst of water (after opening the drain) it will pull the water out the spicket.
+
+ Reverse process (minus the blowout) for spring.