Login
Google Search
Calendar-Filter
|
@@ -Lines: 1-6 changed to +Lines: 1-27 @@
- House Paint:
+ !!__House Paint__
Ceiling = Dover White (supplied by Ryland)
Walls = 413-3 Ostrich Feather (supplied by Ryland)
- Power Room = Behr 720D-4 Ashwood
+ Power Room = Behr 720D-4 Ashwood (Satin)
Girls Bathroom = Behr 370A-2 Pale Daffodil (Satin) For painting behind the toilet, used 4 inch Smooth Services "Better" High density foam and newspaper to cover the back.
+
+ Hardware: + Replacement Pulls in the bedroom - Birdcage Bail Design, SKU=96 926-408 + + !!__Sprinkler System__ + # Turn off water in the basement + # Turn yellow valve off (just above the spicket) + # Use attachment and attach to the right side of the device outside (remove the current one and replace it with the one that should be hanging from the air compressor) + # Run air hose to the attachment, do not attach yet. + # Start the compressor. Set it to 45psi (looking to keep it between 40-50, not over 50psi + # Set the sprinkler to manual, set the first station to 10 minutes (time to finish setting the other stations and get the hose hooked up), set the other stations to 5 minutes. + # Make sure the first station is running, if so, hook up the hose to the attachment + # Air should be pushing out water at station one. + # Wait and watch the other stations, make sure to keep the PSI below 50 + # Remove the air hose. + # Reattach the piece on the right + # Set all valves to half way open. + # Drain the lines to the spickets: The one to the sprinkler needs to drain back into the house. The one to the back, if you give it a quick burst of water (after opening the drain) it will pull the water out the spicket. + + Reverse process (minus the blowout) for spring. |